Are thin spherical shells subjected to shear stress?
Strength of Materials
- Surender
- 05 Nov
- 9 Answers
9 Answers
9 Answers
-
Radial stress(= 0) must be considered as the third principal stress. And the maximum shear stress = (σ1 - σ3)/2 where σ1 = Pd/2t ..........hoop stress σ2 = Pd/4t ..........longitudinal stress σ3 = 0 ................radial stress0Modal content
-
yes. shells are subjected to internal pressure shows hoop stress as well as longitudinal stress. compaire this two axial stress condition with elemental area of shell in which two side of body subjected to axial force. so any section in between them are subjected to normal as well as shear stress.0Modal content
-
No. Because in the spherical cell gas and liquid is filled. And inside pressure work as hydrostatic pressure. And hydrostatic pressure is always normal( perpendicular) to the plane so there is not any shear stress.0Modal content
-
no because it is like a circular sphere0Modal content
-
can any one explain ?0Modal content
-
no0Modal content
-
no0Modal content
-
no0Modal content
-
no1Modal content
View all vote's
Other Related Discussions
-
What is the best way to score good marks in GATE CE?
-
question is regarding survey a survey line was measured to be 60m. it was found that there is misalignment and line was 1m off straight at middle. the correction in length in m is?
-
The bearing capacity of a strip footing on a saturated clay is 120 KN/m2. The bearing capacity of a circular footing (diameter=width) will be. 1. more then 120 2. less then 120 3. equal to 120 4.all
-
gate marks benefit.............................
-
soil has a L.L. of 50% and P.L. 30% . when the soil at L.L. is dried.% decrease in vol. was 40% of dry volume. when it was dried from its P.L. %Dec. in vol. is 20% of its dry vol.Shrinkage limit is:?
-
how to make sound off of this ap
-
explain effect of compaction on dry density ?
-
what is the difference between frame and truss
-
What are the cutoff marks for the GATE 2015?
-
Where can I download all notes for GATE and IES examinations for civil engineering?
