minimum length of shoulder recommended by IRC
question of highway engineering
- Akshay
- 15 Aug
- 34 Answers
34 Answers
34 Answers
-
2.50Modal content
-
2.5 m0Modal content
-
min width of shoulder will be 2.5 m0Modal content
-
Shoulders are provided along the road edge to serve as an emergency lane for vehicle compelled to be taken out of the pavement or roadway. Shoulders also act as service lanes for vehicles that have broken down.
Which gives cross section details of roads in embankment and cutting. The width of the shoulder should be adequate to accommodate stationary vehicle fairly away from the edge of the adjacent lane. It is desirable to have a minimum shoulder width of 4.6 m so that a truck stationed at the side of the shoulder would have a clearance of 1.85 m from the pavement edge.
The minimum shoulder width recommended by the IRC is 2.5 m.1Modal content
-
minimum length of shoulder recommended by IRC is "2.5"0Modal content
-
For single lane 0.65 on one side0Modal content
-
2.50Modal content
-
2.50Modal content
-
2.5m0Modal content
-
2.5m0Modal content
-
2.5m0Modal content
-
2.5 m0Modal content
-
1.50Modal content
-
2.50Modal content
-
2.5m0Modal content
-
2.50Modal content
-
incorrect question , question will be min. width of shoulder5Modal content
- venkatesh
- prapti
- sivaram
- akash
- devasheesh
- venkatesh
- prapti
- sivaram
- akash
- devasheesh
- No Down Vote
-
2.40Modal content
-
1.50Modal content
-
150Modal content
View all vote's
Load More Answers
Other Related Discussions
-
soil has a L.L. of 50% and P.L. 30% . when the soil at L.L. is dried.% decrease in vol. was 40% of dry volume. when it was dried from its P.L. %Dec. in vol. is 20% of its dry vol.Shrinkage limit is:?
-
sfd and BMD for over hanging beam general conditions
-
any body tell me a gate syllabus for civil engg 2016
-
SOM
-
Any one please suggest the preparation tips for GATE Civil Engineering..
-
is it enough to study past 15 years gate paers to pass gate exam
-
The percentage of void ratio in cement is approximately? a) 50% b) 40% c) 30% d)20%
-
density of cement
-
SUGGEST TIPS AND TRICKS FOR GATE CE EXAMINATION
-
The survey in which final alignment is selected is
